Mspa B-121 B-141 Castello Manuel du propriétaire télécharger pdf (Page 10)

l) Place the zipper cover onto the spa and then put the inﬂatable bladder onto the spa pool, Fasten the zip-

per and lock the cover to the spa by using the digital lock in the accessory pack.

Note:

Please remember to test and adjust the air pressure inside of spa pool before each

time of use.

Please cover zipper with wax once a week so as to make it smooth for operation and

avoid split.

How to change the combination of digital lock:

Original combination is set as 000

1) Push release button(a) in the direction of the arrow shown

and the lock will be released.

2) Set your desired combination by move the number wheel(b).

Please do not forget your new combination.

3) Insert back the steel cable(c) to its end in the direction of the

arrow. The new combination is ready for use.

WARNING: Do not move the number wheels while the digital lock is open. Or you will

change the combination you just set. This will unable the digital lock. WARNING: The

cover is not a substitute for adult supervision; Children must be supervised at all

times around the Spa.

WARNING: Water attracts children; Always attach a spa cover and lock it after each

use.

(a)

(b)

(c)

(1)

)3()2(

POWER PACK OPERATION

Warning: to avoid function failure and damage, please do not operate until spa is ﬁlled

with water to the low water mark.

It is the responsibility of the spa owner to make sure the above installation conditions are met as well as to

follow the Safety and Warning Instructions. Any failure and damage, which may result from dry-run, water

spillage, excessive humidity, or structural loading will void the warranty.

Control panel:

2. “BUBBLE” Button: To activate Bubbling system,

which has a 20-minute auto shut off for 10 minutes

feature. The light of bubble Button displays green

when being activated.

NOTE: If it works more than 15 minutes and stop manually,

please wait more than 10 mintues to activate manually again.

3. “FILTER” Button: To activate Filtration system.

The light of “FILTER” button displays green when the ﬁltration system is activated.

4. “HEATER” Button: To activate Heating and Filtration system at the same time.

(Filtration system cannot be turned off when heating)

5. “TEMPERATURE” Button: To set and display water temperature

6. “UP” Button: Increase temperature

7. “DOWN” Button: Lower temperatrure

1 0 0

1. “ON/OFF” Button: To activate power pack.

Meijer.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 34 35

Commentaires sur ces manuels

Pas de commentaire

Mspa B-121 B-141 Castello Manuel du propriétaire Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour piscines hors sol Mspa B-121 B-141 Castello